bannera

Book A.
Introduction

Book B.
7150 Requirements Guidance

Book C.
Topics

Tools,
References, & Terms

SPAN
(NASA Only)

Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Wiki Markup
{alias:SWE-094}
{tabsetup:1. The Requirement|2. Rationale|3. Guidance|4. Small Projects|5. Resources|6. Lessons Learned}

{div3:id=tabs-1}


h1. 1. Requirements

4.4.5 The Requirement

add

 project shall report measurement analysis results periodically and allow access to measurement information by Center-defined organizational measurement programs.

h2. 1.1 Notes

NPR 7150.2A does not include any notes for this requirement.

h2. 1.2 Applicability Across Classes

Classes C-E and Safety Critical are labeled "P (Center) +SO". This means that this requirement applies to the safety-critical aspects of the software and that an approved Center defined process which meets a non-empty subset of this full requirement can be used to meet the intent of this requirement. 

Class C and Not Safety Critical and Class G are labeled with "P (Center)".  This means that a Center defined process which meets a non-empty subset of this full requirement can be used to meet the intent of this requirement. 

Class F is labeled with "X (not OTS)".  This means that this requirement does not apply to off-the-shelf software for these classes.


{applicable:asc=1|ansc=1|bsc=1|bnsc=1|csc=*|cnsc=p|dsc=*|dnsc=0|esc=*|ensc=0||f=*|g=p|h=0}

{div3}
{div3:id=tabs-2}

h1. 2. Rationale

add

{div3}
{div3:id=tabs-3}

h1. 3. Guidance

add

{div3}
{div3:id=tabs-4}

h1. 4. Small Projects

add

{div3}
{div3:id=tabs-5}

h1. 5. Resources

# add
# add


{div3}
{div3:id=tabs-6}

h2. 6. Lessons Learned

add



{div3}
{tabclose}